Evolve EVS Instrukcja Naprawy

Przeglądaj online lub pobierz Instrukcja Naprawy dla Dozowniki wody Evolve EVS. Evolve EVS Troubleshooting guide Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj

Podsumowanie treści

Strona 1 - Evolve ES Series

Evolve ES Series® Water SoftenersFor Models:• ES-844• ES-948• ES-1044• ES-1248• ES-1354

Strona 2 - TABLE OF CONTENTS

5. ERROR MESSAGE: If the word “ERROR” and a number are alternately flashing on the display record the number and contact the dealer for help. This i

Strona 3

11FLUSHING OF SYSTEM:To flush the system of any debris and air after installation is complete, please perform the following steps: 1. Rotate bypass h

Strona 4 - BYPASS VALVE:

128. SANITIZING OF UNIT UPON INSTALLATION AND AFTER SERVICE: At this time, it is advised to sanitize the softener: 1. Open brine tank and remove br

Strona 5 - INSTALLATION:

13 1. No display on PC board A. No power at electric outlet A. Repair outlet or use working outlet B. Control valve power adapter not plugged into

Strona 6

14 7. Control valve does not regenerate automatically but does when the correct button(s) is depressed and held. For timeclock valves the buttons ar

Strona 7 - PROGRAMMING PROCEDURES:

15 12. Control valve fails to draw in regenerant A. Injector is plugged A. Remove injector and clean or replace B. Faulty regenerant piston B.

Strona 8

16 16. E3, Err – 1003, Err – 103 = Control valve motor ran too long and was unable to find the next cycle position A. Motor failure during a regener

Strona 9 - BATTERY REPLACEMENT

17REPLACEMENT PARTS:2713546NOTE: Battery LocationFRONT COVER AND DRIVE ASSEMBLYItem No. Part No. Description Qty.1CV3367-01-A Black cover 1CV3367-01-

Strona 10

18REPLACEMENT PARTS:234511314PISTON ASSEMBLYItem No. Part No. Description Qty.1CV3005 1” spacer stack assembly 1CV3430 1.25” spacer stack assembly 1

Strona 11 - START-UP INSTRUCTIONS:

19BYPASS VALVE Item No. Part No. Description Qty.1 CV3151 Nut, 1” quick connect 22 CV3150 Split ring 23 CV3105 O-ring 215 24 CV3145 Bypass rotor,

Strona 12

Your Evolve Series water softeners are precision built, high quality products. These units will deliver conditioned water for many years to come, when

Strona 13 - TROUBLESHOOTING GUIDE:

20INJECTOR ASSEMBLIESItem No. Part No. Description Qty.1 CV3176 Injector cap 12 CV3152 O-ring 135 13 CV3177-01 Injector screen 14 CV3010-1Z Inject

Strona 14 - TROUBLESHOOTING GUIDE cont’d:

21DRAIN LINE ASSEMBLY 3/4”Item No. Part No. Description Qty.1 CH4615 Elbow locking clip 12 CPKP10TS8-BULK Optional insert, 5/8” tube 13 CV3192 Opti

Strona 15 - PROBLEM CAUSE CORRECTION

22 WATER METER & METER PLUGItem No. Part No. Description Qty.1 CV3151 Nut, 1” QC 12 CV3003 Meter assembly, includes items 3 & 4 13 CV3118-01

Strona 16

232345678101911SAFETY FLOAT BRINE ELBOWItem No. Part No. Description Qty.1 CH4655 474 .5 gpm flow control 12 CV3163 O-Ring 019 13CH4613 3/8” elbow

Strona 17 - REPLACEMENT PARTS:

24INSTALLATION FITTING ASSEMBLIES:1” PVC MALE NPT ELBOWItem No.Part No. Description Qty.CV3007 1” PVC male NPT elbow assembly 21 CV3151 Nut, 1” quic

Strona 18

251-1/4” & 1-1/2” PVC SOLVENTItem No.Part No. Description Qty.CV3007-07 1-1/4” & 1-1/2” PVC solvent assembly 21 CV3151 Nut, 1” quick connect

Strona 19

26 PERFORMANCE DATA SHEET:MODEL ES- 844 ES- 948 ES-1044 ES-1054 ES-1248 ES-1354 Minimum 13,000 @ 3.4 18,000 @ 4.5 18,000 @ 4.5 27,500 @ 7.0

Strona 20

27Evolve Series® Water Conditioner Limited WarrantyCongratulations. You have purchased one of the  nest water treatment systems available. In the unl

Strona 21

MANUAL REGENERATIONNOTE: For softeners, if brine tank does not contain salt, fill with salt and wait at least two hours before regeneration. If you ne

Strona 22

3 PREINSTALLATION INSTRUCTIONS FOR DEALERS:The manufacturer has preset the water treatment unit’s sequence of cycles, cycle times, salt dose, exchange

Strona 23

4The bypass valve is typically used to isolate the control valve from the plumbing system’s water pressure in order to perform control valve repairs o

Strona 24

5GENERAL INSTALLATION & SERVICE WARNINGSThe control valve, fittings and/or bypass are designed to accommodate minor plumbing misalignments. There

Strona 25

67. INSTALLING GROUND: To maintain an electrical ground in metal plumbing of a home’s cold water piping (such as a copper plumbing system), install a

Strona 26 - PERFORMANCE DATA SHEET:

71. Set time of day: PROGRAMMING PROCEDURES:Time of day should only need to be set after extended power outages or when daylight saving time begins or

Strona 27 - Evolve Series

856 STEP 5 – REGENERATION MINUTES: Set the minutes using + or — buttons. Press NEXT to exit installer programming. Press REGEN if you need to return

Strona 28 - QUICK REFERENCE GUIDE:

1. GENERAL OPERATION: When the system is operating, one of three displays may be shown. Pressing NEXT will alternate between the displays. One of the

Komentarze do niniejszej Instrukcji

Brak uwag